DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: sittinguphigh on November 25, 2012, 04:56:25 pm

Title: New etherdongle and conductor firmware programming.
Post by: sittinguphigh on November 25, 2012, 04:56:25 pm

I just built my etherdongle and conductor. Ready to connect the two. Do I program the etherdongle before or after I 
I connect the two.

Title: Re: New etherdongle and conductor firmware programming.
Post by: dpitts on November 25, 2012, 04:58:31 pm

It does not matter.

Title: Re: New etherdongle and conductor firmware programming.
Post by: sittinguphigh on November 25, 2012, 04:59:15 pm

Thanks

Mort

Title: Re: New etherdongle and conductor firmware programming.
Post by: tbone321 on November 25, 2012, 05:00:40 pm

it is easier to connect the Programmer before you connect the two together but as said, it doesn't matter otherwise.

Title: Re: New etherdongle and conductor firmware programming.
Post by: keitha43 on November 25, 2012, 06:01:39 pm

What I did was test my etherdongle first using its firmware to make sure it was working 100% before reflashing with conductor firmware and testing that.

Sent from my Thunderbolt using Tapatalk 2.