DiyLightAnimation

Hardware => Lynx EtherDongle => Topic started by: oj70chevy on February 25, 2013, 11:05:32 pm

Title: EtherDongle Case
Post by: oj70chevy on February 25, 2013, 11:05:32 pm

Sorry but here's another NOOB question. I am getting into the DIY seen and got all parts in for my EtherDongle as well as the case recommended in Wiki. got it all built and realized the case is to small to fit the EtherDongle in it. can some one point me in the right direction to get the right one? by the way the one recommended in Wiki is =
LP-35F LP Series ABS Plastic Enclosure for Electronics
Dimensions (L x W x H) (in / mm) (lbs.)
4.25 x 3.00 x 1.38 in. / 107.95 x 76.20 x 35.05 mm /0.20 lbs.

Thanks
Ralph

Title: Re: EtherDongle Case
Post by: rrowan on February 25, 2013, 11:37:40 pm

Not sure what happen.

My apologies for the wrong number.

Here is the correct case http://www.polycase.com/lp-70p

Updating the wiki also

Rick R.

Title: Re: EtherDongle Case
Post by: oj70chevy on February 26, 2013, 08:04:10 am

Great! Thank you..