DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: testylefty on February 28, 2013, 03:46:56 pm

Title: Purchased programmed PIC?
Post by: testylefty on February 28, 2013, 03:46:56 pm

Is anyone out there offering to sell 3 or 4 programmed PIC's for the wireless DMX unit?

Title: Purchased programmed PIC?
Post by: fertsy on February 28, 2013, 03:51:16 pm

There is a list in the wiki of people willing to program for you.


Sent from my iPhone using Tapatalk

Title: Re: Purchased programmed PIC?
Post by: jnealand on February 28, 2013, 05:11:04 pm

But in the long run you are much better off just getting your own pickit and for the future it should be a pickit 3.  It is a tool you need to be in this hobby just like wire cutters, soldering iron, etc.

Title: Purchased programmed PIC?
Post by: fertsy on February 28, 2013, 11:44:28 pm

Good point. Actually I bought one and can't wait to start using it.


Sent from my iPhone using Tapatalk

Title: Re: Purchased programmed PIC?
Post by: Steve Gase on March 01, 2013, 10:45:04 am

You are not allowed to view links. Register or Login

Thanks again for pointing me in the right direction.  One more question, anyone have a diagram to convert ethernet to dmx (my plan is to eliminate the ethernet jack and install a 3-pin xlr jack)?

we don't call it "ethernet" to avoid the confusion that this jack might carry a network protocol stack.


instead, we use "cat5" to talk about the cabling, and "rj45" to talk about the jacks.


in answer to your question... you only need pins "1" and "2" --  1 carries +DMX and 2 carries -DMX


refer to this page:  http://www.diylightanimation.com/wiki/index.php?title=General_Information_on_Dongle_Connections (http://www.diylightanimation.com/wiki/index.php?title=General_Information_on_Dongle_Connections)