DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: Dholley on April 06, 2014, 03:23:33 pm

Title: Wireless TX/RX Replacement Part for Buffer
Post by: Dholley on April 06, 2014, 03:23:33 pm

Would someone please advise of a replacement part for the buffer (mouser part number ST485BN). The replacement part suggested by mouser is surface mounted. Screen shot attached.

Thank you!

Title: Re: Wireless TX/RX Replacement Part for Buffer
Post by: jnealand on April 06, 2014, 06:15:03 pm

On a non-Lynx project I used this one, but I would see if you get confirmation from other folks agreeing that it would work.

http://www.mouser.com/ProductDetail/Texas-Instruments/SN75176AP/?qs=sGAEpiMZZMutXGli8Ay4kN%2fA1h6iTMmeg8L4Ti1FAL0%3d (http://www.mouser.com/ProductDetail/Texas-Instruments/SN75176AP/?qs=sGAEpiMZZMutXGli8Ay4kN%2fA1h6iTMmeg8L4Ti1FAL0%3d)

Title: Re: Wireless TX/RX Replacement Part for Buffer
Post by: n1ist on April 06, 2014, 06:32:50 pm

It should work, but it's only rated down to 0°C.  Some people have had issues with it in colder climates.
/mike

Title: Re: Wireless TX/RX Replacement Part for Buffer
Post by: Dholley on April 11, 2014, 07:04:35 pm

thank you!!

Danny