DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: therealbigjim on December 01, 2014, 08:26:31 pm
-
my dongle was working a week ago. plugged it in tonight and nothing. no mag jack lights but the power light is on;. I wanted to start my show on Saturday and I am in a little panic. nothing has changed from the working configuration. I suck at searching old posts but I will start. I do have a usb dongle I could flash but would rather have the etherdongle working. I know recently someone else had a similar problem.
-
What do you have the ETD plugged into?
-
Start with simple things:
cat5 cables.
Was new software added to you computer: security, firewall?
How long has it been since your router got restarted?
Check the connectors, plugs, network switches/splitters
Rick R.
-
I am embarrassed <fp. my problem was panic induced. My ETD was plugged directly into my computer. Recently I have doing some sequencing on the go trying to catch up. When I plugged the ETD back up I switched my inputs. The magjack side was plugged in to the input of the of the active hub , and the other side was plugged into my laptop. I was at my wits end....opened up the box the green light is on. I re-flashed the chip...(probably needed it anyway) but still no magjack lights..... until I looked at it again and switched the magjack to connect it to the computer...The lights lit and data was flowing....I have been doing this long enough I should know better but the stress of the little lights not blinking made me loose my mind.
-
Been there, done that. Finally learned what PEBCAK means. When I get stressed out I start making more bad decisions and I've learned that the best thing to do is to walk away for awhile, maybe overnight.