DiyLightAnimation

Hardware => Lynx Smart String => Topic started by: enjoylife22 on December 07, 2016, 05:59:16 pm

Title: 2 ssc v4 leaking data
Post by: enjoylife22 on December 07, 2016, 05:59:16 pm

I have to of the 8 ssc v4 I built this year leaking data on out put.  when I turn on my active hub only two come on all rest of like I want until commanded to light.  Not sure even where to start with these two.

Title: Re: 2 ssc v4 leaking data
Post by: chrisatpsu on December 07, 2016, 10:13:21 pm

what do you mean by leaking data?

Title: Re: 2 ssc v4 leaking data
Post by: enjoylife22 on December 08, 2016, 12:09:49 am

Well it is data that turns the nodes on. I get a rain bow only on two of the sscs when I power up my hub. All the rest stay unlit until I send a signal through xlights. Just two though. Not sure why they send a rainbow affect on start up

Title: Re: 2 ssc v4 leaking data
Post by: tbone321 on December 08, 2016, 01:51:29 am

A rainbow in many cases is indicating a lack of data and noise.  What do you mean that the rest stay lit?

Title: Re: 2 ssc v4 leaking data
Post by: enjoylife22 on December 08, 2016, 11:45:23 am

Ok Tbone I get it now. Yes there is noise so could it be that I have a bad solder joint or cable attachment. I meant to say all the rest are completely off. Now this only occurs when the hub is first turned on. Does not happen after I turn on xlights and say out put to light they go off and never happens again until initial power up of hub