DiyLightAnimation

Hardware => Lynx Aether => Topic started by: rdebolt on November 12, 2010, 11:05:56 am

Title: Making Aether Wireless???
Post by: rdebolt on November 12, 2010, 11:05:56 am

I have 4 Aethers built and am trying to make them wireless. I know that this is a stupid question for most, but how do you wire it to the Aether?  :-[  In RJs last video he shows what he uses and I have servo cables but where do you attach them to the Ex\Rx? I put a 3 pin jumper on my Aethers so that I can just plug the servo cable in , but I don't know how to adapt my antenna.


On a positive note these things are BRIGHT!!!!  <fp. 8)

Title: Re: Making Aether Wireless???
Post by: basis21b on November 12, 2010, 11:56:57 am

In the wiki under the EX/RX Version 1 device there is a link labeled: "Mod for other controllers".  See the link below.

http://diylightanimation.com/wiki/index.php?title=Mod_Wireless

Title: Re: Making Aether Wireless???
Post by: rdebolt on November 12, 2010, 12:37:50 pm

Thanks Tom! That's exactly what I was looking for I just could not find it! I kept looking under version 2 since that's what I have!  <fp. Tomorrow I will hope fully have 4 wireless Aethers!   >.d9  <;d