DiyLightAnimation
Hardware => Lynx Wireless DMX => Topic started by: mmciver on February 04, 2012, 12:42:04 am
-
When you are setting up the EX/RX for Wireless with something like the SSR4, on the documentation on the wiki is the EX/Rx picture facing the front of the board or the back?
In other words, the picture on the wiki shows wires going to 3 pins on the EX/RX, but is it showing the front of the board or the back?
Makes a bit difference in the wiring!
Just curious.
Mike.
-
in that drawing, you are looking at the front of the EX/RX. The wire going into the lower right hand hole is GND.
Here is one prepped and ready to be used.
Larry
-
Thank you for the clarification. I never questioned it until I went to.build one, then the position wasn't as clearly marked as I would have liked.
In otherwords it wasn't 100% idiotproof. Me being the idiot:)
Mike
Sent from my ADR6400L using Tapatalk
-
One other note that I learned after the fact is that the wireless antenna should be facing up when the case is closed. I had mine taped to the lid with double sticky tape with the antenna up, but then realized when I closed the lid it would be antenna down. They seemed to work ok, but I did go back and change them. I want to be sure I am getting the maximum signal to these little puppies no matter where I happen to be using them.