DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Slave => Topic started by: sabie on September 19, 2012, 01:09:32 pm

Title: when will software for slave and manual be posted in wiki
Post by: sabie on September 19, 2012, 01:09:32 pm

when will software for slave and manual be posted in wiki

Title: Re: when will software for slave and manual be posted in wiki
Post by: rrowan on September 19, 2012, 01:35:28 pm

As soon as RJ and the beta team send it to me.

Sorry I can't give you a date. We "Normally" try before people get their stuff from the first coop.

Rick R.

Title: Re: when will software for slave and manual be posted in wiki
Post by: tng5737 on November 07, 2012, 05:27:41 pm

Any update on this?

Title: Re: when will software for slave and manual be posted in wiki
Post by: dearvbguru on October 25, 2013, 12:25:48 pm

Ping...

Any idea if we will have the slave firmware to use this season?

Title: Re: when will software for slave and manual be posted in wiki
Post by: RJ on October 25, 2013, 01:44:09 pm

It is in the works but can not promise when it will be released. I was hopeing to get more feedback on the conductor to make sure we are good before we put the slave out. It is almost ready to be tested again but I have been limited in the time I had to work on it do to work and home. I put so much time in on the conductor that I was behind on other things and had to put time into them. 

RJ

Title: Re: when will software for slave and manual be posted in wiki
Post by: dearvbguru on October 25, 2013, 03:33:34 pm

Thanks for the update RJ. I have had my two conductors with the latest firmware since the beginning of October and have had no issues with it at all.  Ones inside and one is outside running different shows on different schedules. If you need help with testing the slaves I can help