DiyLightAnimation

Hardware => Bobcat DMX Tester => Topic started by: devoidelk on September 25, 2012, 05:27:14 am

Title: I may be missing something.....
Post by: devoidelk on September 25, 2012, 05:27:14 am

So what does the tester actually do?

Does it allow you to test individual channels to see if there working or what?

EX....Just hardwire it into the LE input and use it to send signals to the channels.

Sorry if I missed where this was discussed i was on the forums when it was being developed but never payed attention. <fp. <fp...

Thanks

Todd

Title: I may be missing something.....
Post by: rm357 on September 25, 2012, 06:35:46 am

Yes.
Using the switches and the knob, you can select channel number from 1 to 512 and data value for that channel. There is also an all channels selection and a data pulse which will continuously pulse the selected channel.

The 4 position switch allows you to select hard-wired (top) or, if the wireless module is installed, transmit on wireless universe 1, 2, or 3.

Title: Re: I may be missing something.....
Post by: devoidelk on September 25, 2012, 12:48:02 pm

Might pick one up next time theres a coop for it. Sounds like a fun toy