1
Finished COOPS / Re: 16 Port Active Hub, 4 Port Passive Hub,16 Port Passive Hub**ALL SHIPPED*
« on: April 14, 2014, 09:54:37 pm »
Mine came in today. Thank you
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Finished COOPS / Re: COOP #1 of 2014: 16 Port Active Hub, 4 Port Passive Hub,16 Port Passive Hub!!!
« on: February 07, 2014, 03:59:18 pm »
3 kit 1
3 kit 4
3 kit 4
3
The Porch / Re: New Show for 2014
« on: January 12, 2014, 01:24:31 pm »
We have two Expresses two freestyles one lynx and a DMX dongle. Plan on building a RGB mega tree 180 deg 16 strand 50 node. Six small trees 180 deg 8 strand 20 node six arches 50 node each and twelve candy cane 14 node each. I plan on ordering all the lights from the Wiki unless there will be a coop soon. The other hardware is up in the air. I was thinking of going all PixelNet 16 Port Active Hub just thinking down the road here and SSC for every strand.
4
The Porch / New Show for 2014
« on: January 11, 2014, 11:00:00 pm »
Need some help. I have been animating lights since 2008 but because I started a new business we have not had a display for the last couple of years. Now that the business is doing well we are getting back into Christmas lights again. I would like to add pixel to my mega tree six small trees and all my arches and canes. I am VERY new at the RGB side so I need some help figuring out what hardware would be the best fit.
5
Lynx Express / Re: express dmx light
« on: August 23, 2009, 09:04:12 pm »
How can we field test DMX with wireless then? If a unit stops wowking and you see the DMX light on how can you tell if it is getting a signal from the receiver?
Thanks for the quick replies.
And thank you RJ for all your hard work!!
Thanks for the quick replies.
And thank you RJ for all your hard work!!
6
Lynx Express / express dmx light
« on: August 23, 2009, 07:17:55 pm »
Today i was testing the wireless with the new code . I plugged in the wireless receiver into the express ver 3.0 board and pulled the rs 485 chip. Ran it in test mode and the ZC,DMX, and Done came on but here is my problem. I did not have dmx going to it eather by wireless or cable should the DMX light be off.
9
Finished COOPS / Re: ***********Open Lynx Wireless Parts Only Kit Co-Op**************
« on: May 03, 2009, 11:24:36 pm »
2 Kit # 1
1 Kit # 2
4 Kit # 3
Thank You
1 Kit # 2
4 Kit # 3
Thank You
10
Finished COOPS / Re: Case Coop
« on: May 02, 2009, 09:18:08 am »
2 - Wireless TX case # 2
4 - Wireless RX case # 3
Thank You
4 - Wireless RX case # 3
Thank You
11
Finished COOPS / Re: Lynx Wireless DMX Coop
« on: April 12, 2009, 10:20:28 am »
2 - TX
2 - EX/RX
4 - RX
Thank You
2 - EX/RX
4 - RX
Thank You
12
Finished COOPS / Re: ********OPEN 3rd Lynx Express Coop********
« on: March 04, 2009, 05:22:28 pm »
RJ please put me down for
2 Kit#1
Thank You
2 Kit#1
Thank You
Pages: [1]