Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bob81354

Pages: [1]
1
Lynx Express / DMX channel count
« on: December 17, 2016, 07:31:13 pm »
Hi to all
I have 3 Lynx Express and a 30 channel DMX controller and I am trying to get my channel count right
So when you plug your 30 channel controller in to DMX 2 out of the Le controller does it have to be in the last LE controller or can it be in any of the 3 and start at channel 49
Thanks Bob

2
Lynx USB DMX Dongle / need help
« on: November 19, 2013, 12:20:12 am »
Hi to all
I just bought  6 coro canes  and there tiny pix controller and  100 smart  Rectangle RGB leds and I have a usb dmx dongle and the L express  what I need to no is how mush power I need to run this ?
and can I use my usb dmx dongle  if I change the firmware instead or do I need to buy the USB DMX Module Programmer wire
and a hub with dmx output to the L express?
and I just wanted to get a few candy canes
any help would be appreciated
Thanks Bob   

3
Sale/Trade / Re: FS TX/RX v2.0
« on: October 12, 2013, 10:18:29 pm »
Hi Mike
do you still have one left ? if you do I will take it
Thank Bob

4
Lynx Express / need sequecen
« on: December 19, 2012, 01:41:27 am »
Hi to all and merry Christmas
I just finished my first 2 lynx express and they tested OK now I like to try it out but it takes so long to do a sequence and it's all most Christmas I was wondering if any one has a  couple of sequence I can use ! I have only 18 or 20 channels set up right now .and can you just run one side of the board if you have 20 channels or do you have to run both sides of the board ? I would appreciate any help you can give.
Thanks Bob


5
Lynx Express / need help #6 led on
« on: December 02, 2012, 04:28:57 am »
HI to all
I just finished my first LE and all i  get is the 3.5 v & 5v  and the #6 leds on
I think i programed my chip right  but no go and all my sodering looks good
thanks Bob

6
Lynx USB DMX Dongle / PICIT 2 hook up
« on: November 25, 2012, 03:24:23 am »
Hi to all
I just finished my first DMX Lynx USB Dongle and i bought the pickit 2 it came with a usb wire I can not see how to hook it to the DMX Lynx USB Dongle board to program and to the L Express board
do i need to get some thing else
sorry for the ED and i put it in thee wrong place

Pages: [1]