Build Tip

[wbuehler]

I went to Lowes and had them cut two pieces of Lexon for me.

One at 1" wide the other at 3/4" wide to use as a guide.

Bill

[jnealand]

This does not help me.  What is it used for?

[wbuehler]

The one inch and 3/4 measurements used to mount the Side Pieces of angle to the case.

Bill

[wbuehler]

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

[rdebolt]

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Hey Bill,

Nice picture and great idea on the lexan.  How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.

Thanks,
Roger

[batdive]

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Hey Bill,

Nice picture and great idea on the lexan.  How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.

Thanks,
Roger

Here you go...  

Pin 1 (top left pin) is empty
Pin 2 (Signal Wire ) In this case white wire if using servo extensions
Pin 3 (+5)  Red wire
Pin 4 empty
Pin 5 (Bottom right pin) ground
Pin 6,7,8 empty

[rdebolt]

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Hey Bill,

Nice picture and great idea on the lexan.  How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.

Thanks,
Roger

Here you go... 

Pin 1 (top left pin) is empty
Pin 2 (Signal Wire ) In this case white wire if using servo extensions
Pin 3 (+5)  Red wire
Pin 4 empty
Pin 5 (Bottom left pin) ground
Pin 6,7,8 empty

Perfect! Thank you!