I have a flickering problem on 3 LE's that I just can't figure out (and from what I can see they are all incandescent channels). After testing every combination known to man including different network cables, different network cables run, separating data and power, multiple dongles (Entec, Lynx, ED) ,multiple different LE controller swaps, firmware updates, terminators at all ends, different extension cords, different outlets, LOR S3, xlights, recreating the sequence and even isolating my show to just this one controller (laptop, dongle and cat5 cable. Other than this the other 25+ LE's are happy campers.
I think I have tried every combination known to man and the only thing I found so far for one controller is to eliminate programming on two channels. Why this make a difference I have no idea. As for responding to commands that they should they do this just fine.
My next test is to build a spare LOR board I had stashed just to see if that makes a difference but I'm not holding my breath. I have used the same gear the last 3-4 of years and never remember seeing anything like this.
Is there anything that I could be missing? I've tried so many different things the problem could be staring at me and I might not see it.
