Difference between revisions of "Template:Set Address"
From Holiday Controller
(New way to program Start Address) |
m |
||
| Line 1: | Line 1: | ||
Updated way to program the Lynx Controller. | Updated way to program the Lynx Controller. | ||
| − | + | Step 1 - '''Turn off power to controller and move jumper to program mode''' | |
| − | + | Step 2 - '''Run RJ's Lynx Address Program and select address you need. Click on Program button''' | |
| − | + | Step 3 - '''Turn on controller and count to 5''' | |
| − | + | Step 4 - '''Turn off controller and move jumper back to operation mode''' | |
| − | + | Step 5 - '''Click Stop on the Lynx Address Program''' | |
| − | + | Step 6 - '''Turn on controller and use your selected program to see if controller is now on the correct start address.''' | |
Either exit Lynx Addrress Program or go back to step 1 to program another controller | Either exit Lynx Addrress Program or go back to step 1 to program another controller | ||
Revision as of 17:10, 7 November 2010
Updated way to program the Lynx Controller.
Step 1 - Turn off power to controller and move jumper to program mode
Step 2 - Run RJ's Lynx Address Program and select address you need. Click on Program button
Step 3 - Turn on controller and count to 5
Step 4 - Turn off controller and move jumper back to operation mode
Step 5 - Click Stop on the Lynx Address Program
Step 6 - Turn on controller and use your selected program to see if controller is now on the correct start address.
Either exit Lynx Addrress Program or go back to step 1 to program another controller
