Difference between revisions of "Template:Set Address"
From Holiday Controller
m |
m (little clean up) |
||
| Line 1: | Line 1: | ||
| − | + | To program the Lynx Controller/Dimmer. | |
Step 1 - '''Turn off power to controller and move jumper to program mode''' | Step 1 - '''Turn off power to controller and move jumper to program mode''' | ||
| Line 13: | Line 13: | ||
Step 6 - '''Turn on controller and use your selected program to see if controller is now on the correct start address.''' | Step 6 - '''Turn on controller and use your selected program to see if controller is now on the correct start address.''' | ||
| − | Either exit Lynx Addrress Program or go back to step 1 to program another controller | + | '''Either exit Lynx Addrress Program or go back to step 1 to program another controller''' |
Revision as of 19:56, 7 November 2010
To program the Lynx Controller/Dimmer.
Step 1 - Turn off power to controller and move jumper to program mode
Step 2 - Run RJ's Lynx Address Program and select address you need. Click on Program button
Step 3 - Turn on controller and count to 5
Step 4 - Turn off controller and move jumper back to operation mode
Step 5 - Click Stop on the Lynx Address Program
Step 6 - Turn on controller and use your selected program to see if controller is now on the correct start address.
Either exit Lynx Addrress Program or go back to step 1 to program another controller
