Difference between revisions of "Template:Set Address"

Revision as of 17:10, 7 November 2010

Updated way to program the Lynx Controller.

Step 1 - Turn off power to controller and move jumper to program mode

Step 2 - Run RJ's Lynx Address Program and select address you need. Click on Program button

Step 3 - Turn on controller and count to 5

Step 4 - Turn off controller and move jumper back to operation mode

Step 5 - Click Stop on the Lynx Address Program 

Step 6 - Turn on controller and use your selected program to see if controller is now on the correct start address.

Either exit Lynx Addrress Program or go back to step 1 to program another controller