« previous next »
Pages: [1]

Author Topic: DSC programming  (Read 924 times)

lightsup

  • Full Member
  • ***
  • Posts: 87
    • View Profile
DSC programming
« on: October 16, 2013, 08:05:04 pm »
Hi can the DSC start address be programme with the dmx dongle. I have been trying for the last hour with Smart String Controller Configuration with no result its transmitting but don't seem to programme the start add. is there a FAQ on the SSC configuration software. here the settings on the Smart String Controller Configuration . start channel 1. usb dongle selected. 3 channel string. forward selected by default. node count 1. null mode 0 . string selected. click on transmit. now how long do you wait till it stops or do a manual stop. the DSC is set to program with 12 volt on. Please HELP.
Logged
Just do it.

jnealand

  • Patron Member
  • Sr. Member
  • ****
  • Posts: 2494
    • View Profile
Re: DSC programming
« Reply #1 on: October 16, 2013, 09:08:43 pm »
You can use the USB dongle flashed with pixelnet firmware.  The USB dongle flashed with DMX firmware will not work.
Logged
Jim Nealand
Kennesaw, GA

lightsup

  • Full Member
  • ***
  • Posts: 87
    • View Profile
Re: DSC programming
« Reply #2 on: October 16, 2013, 10:07:35 pm »
well I flash the dongle with the pixelnet, got it to program but its not responding with RJ dmx deck or vixen. I am done for tonight. Thanks for the help jnealand I got one step forward, I will try again tomorrow. good night.
Logged
Just do it.

lightsup

  • Full Member
  • ***
  • Posts: 87
    • View Profile
Re: DSC programming
« Reply #3 on: October 17, 2013, 01:51:09 pm »
Thanks Jim it works . :)
Logged
Just do it.
Pages: [1]
« previous next »