« previous next »
Pages: [1]

Author Topic: Powering the tx from an LOR header  (Read 3056 times)

i1uhrace

  • Full Member
  • ***
  • Posts: 87
    • View Profile
Powering the tx from an LOR header
« on: September 26, 2015, 11:06:50 pm »
I'm trying to power my wireless tx from the J0 header on an LOR board. It has a 5v output and was wondering if anyone knows if it'll run off 5v or if I need to use the 10v pin and put a small DC-DC voltage reducer in line to take it to 6v?
Logged
Carnation Christmas

i1uhrace

  • Full Member
  • ***
  • Posts: 87
    • View Profile
Re: Powering the tx from an LOR header
« Reply #1 on: September 27, 2015, 12:20:44 pm »
Never mind I went ahead and tried it and it seems to work from the 5v.
Just need to run some test sequences to be for sure.
Logged
Carnation Christmas

i1uhrace

  • Full Member
  • ***
  • Posts: 87
    • View Profile
Re: Powering the tx from an LOR header
« Reply #2 on: November 22, 2015, 11:12:37 am »
I ended up having to move it to the 9vdc pin but so far so good.
Logged
Carnation Christmas
Pages: [1]
« previous next »