« previous next »
Pages: [1]

Author Topic: It helps to read the top thread!  (Read 1727 times)

Deast

  • Jr. Member
  • **
  • Posts: 22
    • View Profile
It helps to read the top thread!
« on: October 31, 2009, 02:48:50 pm »
After re-flashing both of my SSR4's and dongle I was still having problems with channels coming on when they weren't supposed to.    I cut the 5 lines between the two rj45 jacks..... FIXED!!!!!

Time to get the Halloween lights up.
Logged

RJ

  • Administrator
  • Sr. Member
  • *****
  • Posts: 8519
    • View Profile
Re: It helps to read the top thread!
« Reply #1 on: October 31, 2009, 04:56:55 pm »
You had some of the original SSR pcbs then. If they say SSR4 V2.0 on the pcb you do not have to do this. If they are Ver 1.0 you do.

RJ
Logged
Innovation beats imitation - and it's more satisfying

Deast

  • Jr. Member
  • **
  • Posts: 22
    • View Profile
Re: It helps to read the top thread!
« Reply #2 on: October 31, 2009, 05:03:00 pm »
They were the V1 boards.  I have not had a chance to run both at once until today (for my Halloween display).  One at a time, they ran perfect when I first tested them.  But when I hooked both up, there were some strange happenings.  Lights coming on when they were not supposed to be.  At first I thought that it was just because it is the 31st of October, but then I remembered reading something about traces.......
Logged
Pages: [1]
« previous next »