What we don't like to see

[Brad]

I had a little time yesterday before the Trick or Treaters started to flood the streets. Decided to run the 1st test on LE #2, Ver 4. Plugged all chl's into mini lights, had Vixen ready when it happened. Applied power to the PCB and...."poof"....then nothing.
Will remove it from the enclosure this morning and figure out what, and more important, why it happened.
Stay tuned. I'm sure I'll have questions.

Brad

[WWNF911]

I had a little time yesterday before the Trick or Treaters started to flood the streets. Decided to run the 1st test on LE #2, Ver 4. Plugged all chl's into mini lights, had Vixen ready when it happened. Applied power to the PCB and...."poof"....then nothing.
Will remove it from the enclosure this morning and figure out what, and more important, why it happened.
Stay tuned. I'm sure I'll have questions.

Brad

Man that sucks! I was just gonna contact you to see if you wanted to flash some PICs. (Was a little busy yesterday)
I'll give you a call.

Having nightmares about running out of time and hoping the LE gremlins can't find their way to my house.

Leon

[Brad]

Thanks Leon. This must be my lucky day
I should run down and lay a hundred on the Pass Line at the Nugget 

Started to really get worried when under bright light I could see no burnt components. That should be good news. But I could not identify what caused the "phttt" when plugged in yesterday.
Figured I'd check the pic. Did not look properly seated. Pulled it out re-seated it, plugged it in....and.....I HAVE BLINKING LIGHTS
So lucky not to have fried something.

Brad

[ThaiWay]

Lucky you Brad! 

John